| Initialising telephone/telematics control unit -J526- |
| Initialisation must be performed: |
| t
| On initial commissioning before delivery to customer |
| t
| Following change of vehicle owner |
| t
| After SIM card replacement |
| t
| Following control unit replacement |
| During initialisation, data is exchanged between the telematics control unit and the service centre. |
| Initialisation can only be performed following receipt of the reply to the release fax and release of the SIM card. |
| l
| Adequate reception of D2 mobile radio telephone network |
| l
| Reception of at least 4 GPS satellites |
| l
| Second mobile radio telephone card not fitted in handset |
| “Service mode” appears in display. |
| –
| Keep pressing Navi key until “Security code” appears in display. |
| –
| Enter security code (always “12345”) via keypad and confirm entry by pressing Navi key. |
| Security code should be stored. |
| –
| Then enter number of telematics centre: “49 172 227 022 0” and confirm entry with Navi key. |
| –
| Enter number of telematics provider: “2002” and confirm entry with Navi key. |
| Unit initialisation now commences (approx. 3 to 6 minutes). |
| “New vehicle data received” then appears in display. |
| –
| Confirm display by pressing Navi key. |
| “Telematics data received” appears in display. |
| –
| Confirm display by pressing Navi key. |
| The vehicle data transmitted can then be compared with the entries on the release fax. |
| –
| Press arrow keys to scroll through this menu. Press C key to return to first menu level. |
| This completes initialisation procedure. |
| Dynamic navigation must be activated in the case of vehicles with navigation systems RNS 4.1 and BNS 4.0: |
| –
| Under menu item “Alternative route always automatic” |
| –
| Under menu item “Traffic info source” |
| –
| Under menu item “Traffic info enquiry rate” |
| The units are now ready for operation. |
|
|
|
