A3 L4-2.0L Turbo (BPY) (2006)
17 - Bolt
‹› 130 Nm plus an additional 90° turn
‹› Always replace
‹› Always tighten threaded connections in curb weight position. Refer to => [ Rear Axle in Curb Weight Position ] See: Steering and
Suspension/Suspension/Service and Repair/Rear Axle in Curb Weight Position
18 - Bolt
‹› 5 Nm
‹› Installed on vehicles with Audi magnetic ride, quantity 2
‹› installed on vehicles with headlamp range control, quantity 3
19 - Bolt
‹› 5 Nm
20 - Left Rear Level Control System Sensor (G76), Right Rear Level Control System Sensor (G77)
‹› Removing and Installing, refer to => [ Rear Level Control System Sensors ] See: Sensors and Switches/Sensors and Switches - Steering and
Suspension/Sensors and Switches - Suspension/Ride Height Sensor/Service and Repair/Removal and Replacement/Rear Suspension/Rear
Level Control System Sensors
‹› The sensor lever must face toward the outside of the vehicle.
21 - Upper Control Arm
‹› Removing and Installing, refer to => [ Upper Transverse Link ] See: Steering and Suspension/Suspension/Rear Knuckle Alignment
Link/Service and Repair/Removal and Replacement/Rear Suspension/Upper Transverse Link
22 - Washer
23 - Nut
‹› Always replace
24 - Wheel Bearing Housing
‹› Removing and Installing, refer to => [ Wheel Bearing Housing ] See: Maintenance/Wheels and Tires/Wheel Bearing/Service and
Repair/Removal and Replacement/Rear Suspension/Wheel Bearing Housing
‹› Different versions made of aluminum and steel.
25 - Washer
26 - Bolt
‹› 130 Nm plus an additional 90° turn
‹› Always replace
‹› Always tighten threaded connections in curb weight position. Refer to => [ Rear Axle in Curb Weight Position ] See: Steering and
Suspension/Suspension/Service and Repair/Rear Axle in Curb Weight Position
27 - Tie Rod
‹› Closed in direction of travel
28 - Bolt
‹› 90 Nm plus an additional 45° turn