A3 L4-2.0L Turbo (BPY) (2006)
‹› Installed on vehicles with Audi magnetic ride, quantity 2
‹› Installed on vehicles with headlamp range control, quantity 3
17 - Bolt
‹› 5 Nm
18 - Left Rear Level Control System Sensor (G76), Right Rear Level Control System Sensor (G77)
‹› Removing and Installing, refer to => [ Rear Level Control System Sensors ] See: Sensors and Switches/Sensors and Switches - Steering and
Suspension/Sensors and Switches - Suspension/Ride Height Sensor/Service and Repair/Removal and Replacement/Rear Suspension/Rear
Level Control System Sensors
‹› The sensor lever must face toward the outside of the vehicle.
19 - Bolt
‹› 130 Nm plus an additional 90° turn
‹› Always replace
‹› Always tighten threaded connections in curb weight position. Refer to => [ Rear Axle in Curb Weight Position ] See: Steering and
Suspension/Suspension/Service and Repair/Rear Axle in Curb Weight Position
20 - Washer
‹› Installed on vehicles with an aluminum wheel bearing housing
‹› Serves as corrosion protection
‹› Always install
21 - Upper Control Arm
‹› Removing and Installing, refer to => [ Upper Transverse Link ] See: Steering and Suspension/Suspension/Rear Knuckle Alignment
Link/Service and Repair/Removal and Replacement/Rear Suspension/Upper Transverse Link
22 - Nut
‹› Always replace
23 - Washer
24 - Nut
‹› Always replace
25 - Wheel Bearing Housing
‹› Different versions: aluminum and steel
‹› Removing and Installing, refer to => [ Wheel Bearing Housing ] See: Maintenance/Wheels and Tires/Wheel Bearing/Service and
Repair/Removal and Replacement/Rear Suspension/Wheel Bearing Housing
26 - Washer
‹› Installed on vehicles with an aluminum wheel bearing housing
‹› Serves as corrosion protection
‹› Always install
27 - Washer