A3 L4-2.0L Turbo (BPY) (2006)
Vehicles with manual transmission:
-
Remove cover with selector lever boot.
Vehicles with automatic transmission:
-
Version I: Remove selector lever cover.
-
Version II: Remove selector lever boot and cover.
All:
-
Remove bolt - 2 -.
-
Remove screws - 4 - and - 5 -.
-
Remove grab handle - 3 - or - 6 -.
Installing
Installation is reverse of removal, but note the following:
-
Follow bolt installation sequence:
-
First tighten bolt - 2 -, then bolt - 4 - and finally bolt - 5 - to specified tightening torque.
-
Ensure omega clips are in the correct installation position to clip in shift mechanism cover.
-
Before installing front storage compartment cover or storage compartment trim, install grab handle - 3 - or - 6 -.
4
-
Screw 3.5 Nm
5
-
Screw 3.5 Nm
6
-
Left grab handle
7
-
Center console
Cover with selector lever boot, removing and installing
-
Open ashtray in center console.
-
Remove cover - 1 - with selector lever boot - 2 - upward.
Installation is reverse of removal.
Version I: Selector lever cover, removing and installing
-
Open ashtray in center console.
-
Remove selector lever cover upward - arrows -.
Installation is reverse of removal.