A3 L4-2.0L Turbo (BPY) (2006)
Trim Panel: Service and Repair
Sill Panel Trim
Sill Panel Strip, Removing And Installing
1
-
Sill panel trim
Removing
-
Remove lower A-pillar trim
-
Unclip spring clips - 5 - on front and rear sill panel strip - 1 - from sill - 3 -.
-
Open tab - 6 - and remove seat belt from sill panel strip.
-
Unclip sill panel strip from lower B-pillar trim - 2 -.
-
Remove sill panel strip upward.
Installing
Installation is reverse of removal, but note the following:
NOTE: Replace spring clips if damaged.
-
Install lower A-pillar trim.
-
Ensure floor cover is clamped under sill panel strip without wrinkles.
-
Pull rubber lip of door seal - 4 - over edge of sill panel strip.
2
-
Lower C-pillar trim
3
-
Sill
4
-
Door seal
5
-
Spring clips
-
Replace if damaged
6
-
Belt guide