A3 L4-2.0L Turbo (BPY) (2006)
Utility Storage Compartment: Service and Repair
Driver Side Knee Bar
5
Left Knee Bar
‹› Removing
-
Remove glove compartment. Refer to => [ Glove Compartment ] See: Glove Compartment.
-
Remove bolts - 6 - and - 7 -.
-
Remove knee bar on central tube - 1 -.
‹› Installing
To install, perform the steps used in removal in reverse order.
6
Bolt
9 Nm
7
Bolt
9 Nm
Right Vent Temperature Sensor (G151)
Removing
-
Rotate Right Vent Temperature Sensor (G151) - B - 90° in - direction of arrow -.
-
Remove Right Vent Temperature Sensor (G151) from air duct.
‹› The electronic connector - A - must not be disconnected.
Installing
Installation is reverse of removal, but note the following:
-
When rotating Right Vent Temperature Sensor ( G151), ensure sealing ring - C - is not pinched.