audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Transmission Fluid Level, Checking and Filling Up|Page 3948 > < Transmission Fluid Level, Checking and Filling Up|Page 3946
Page 3
background image

Display on VAS 5051 A :
-

Read transmission fluid temperature in display field - 1 -.

-

If a transmission fluid temperature of 35°C is reached, remove transmission fluid check plug - B -.

Note: 
^

The check plug - B - is located next to the pendulum support. If the drain plug - A - is opened instead, all of the transmission fluid will be
drained!

The transmission fluid present in overflow tube - arrow 2 - drains out first. 

Note: 
^

Even with a low fluid level, a small amount of transmission fluid will leak out of the overflow tube, because it becomes filled during operation.

-

Verify that the overflow tube is screwed into the transmission to 3 Nm and tighten if necessary.

Note: 
^

If the overflow tube is not properly fastened, the correct fluid level cannot be determined.

-

Allow excess transmission fluid to drain off.

The transmission fluid level is correct if a small amount of fluid drips out when transmission fluid temperature is between 35°C and 45°C (this occurs
as the fluid expands via heating up).

In this case, no transmission fluid must be added; the fluid level is OK. 

Transmission Fluid Level, Checking and Filling Up|Page 3948 > < Transmission Fluid Level, Checking and Filling Up|Page 3946