A3 L4-2.0L Turbo (BPY) (2006)
-
If necessary, repair the faulty wiring connection.
If no malfunction is detected in the wiring and if the voltage supply was OK:
-
Replace the Throttle Position (TP) Sensor G79 / Accelerator Pedal Position Sensor 2 G185.
If no malfunction is detected in the wiring and if the voltage supply was not OK:
-
Replace the Motronic Engine Control Module (ECM) J220.
-
Install the drivers side storage compartment.
Final procedure
After the repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory. See: Testing and Inspection/Scan Tool Testing and Procedures/Diagnostic Modes 01 - 09/Diagnostic Mode 03 - Read
DTC Memory
2. If necessary, erase the DTC memory. See: Testing and Inspection/Scan Tool Testing and Procedures/Diagnostic Mode 04: Reset/Delete
Diagnostic Data
3. If the DTC memory was erased, generate readiness code.
-
End of diagnosis.