A3 L4-2.0L Turbo (BPY) (2006)
-
Using a Multimeter , check the following wiring connections for voltage.
Throttle Position (TP) Sensor
Specified value
G79/ Accelerator Pedal Position
Sensor 2 G185 electrical
harness connector terminal
1 to Ground (GND)
about 5 V
1 to 5
about 5 V
2 to Ground (GND)
about 5 V
2 to 3
about 5 V
-
Switch the ignition off.
If the specification was not obtained:
If the manufacturers test box is being used. Perform the following step.
-
Install the test box.
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Motronic Engine Control Module (ECM) J220.
-
Using a Multimeter , check the Throttle Position (TP) Sensor G79 / Accelerator Pedal Position Sensor 2 G185 electrical harness connector
terminals to the Motronic Engine Control Module (ECM) J220 electrical connector T94 for an open circuit.
Throttle Position (TP) Sensor
Motronic Engine Control Module
G79/Accelerator Pedal Position
(ECM) J220 electrical connector
Sensor 2 G185 electrical
T94 terminals or test box sockets
harness connector terminals
1
58
2
80
3
78
4
79
5
56
6
57
Specified value: 1.5 Ohms max.
If the specification is not obtained:
-
Check the wiring for a short circuit to each other, Battery (+), and Ground (GND).
-
Check the electrical harness connector for damage, corrosion, lose or broken terminals.