A3 L4-2.0L Turbo (BPY) (2006)
Communications Control Module: Service and Repair
Data Bus On Board Diagnostic Interface J533, Removing And Installing
Location: At instrument panel carrier above accelerator pedal
Removing
-
If J533 is to be replaced, connect VAS 5051/5052 and initiate OBD program option "J533. Data Bus On Board Diagnostic Interface, replacing"
CAUTION:
-
Switch off all electrical consumers.
-
Switch ignition off and remove ignition key.
-
Remove drivers storage compartment or lower left instrument panel trim
-
Release control module -1- - arrows- and detach from instrument panel carrier.
-
Disconnect electrical connection -2-.
Installing
Install in reverse order of removal, noting the following:
-
Install drivers storage compartment.