A3 L4-2.0L Turbo (BPY) (2006)
Air Bag Control Module: Service and Repair
Airbag Control Module J234 , Removing and Installing
Airbag Control Module J234, Removing And Installing
Special tools, testers and auxiliary items required
-
Torque wrench V.A.G 1410
Removing
-
If the control module is replaced, select "Replace" function for respective control module in "Guided Fault Finding".
CAUTION: Observe safety precautions for work on airbags.
-
Clamp off ground wire at battery with ignition switched off.
-
Remove center console.
-
Open securing clip - 3 - on connector - 4 -.
-
Remove connector - 4 -.
-
Remove nuts - 2 - (qty. 3).
-
Remove Airbag Control Module J234 - item 1 - toward left.
Installing
Installation is reverse of removal, but note the following:
-
When installing a new Airbag Control Module J234 , a new cover must be bonded on.
-
Switch on ignition.
CAUTION: No one should be in vehicle when connecting battery.
-
Connect battery.
NOTE:
-
If Airbag Malfunction Indicator Lamp (MIL) K75 indicates a fault after installation, DTC memory must be checked, deleted and then checked
again.
-
After replacing Airbag Control Module J234, it must be coded in "Guided Fault Finding".
Tightening torque