A3 L4-2.0L Turbo (BPY) (2006)
![background image](/audi/a3/l4-2.0l_turbo_(bpy)/Page-4549003.png)
-
Secure spring clamp on boot using hose clamp pliers (VAG 1275).
-
Slide boot on to steering gear housing.
-
Tighten new clamp using locking pliers (VAS 6199 ) to the extent depicted in the illustration.
Further installation is in the reverse sequence to removal.
Tightening Specifications, refer to => [ Electromechanical Steering Gear Assembly Overview, Generation II and III ] See: Steering Gear/Service and
Repair/Removal and Replacement/Electromechanical Steering Gear Assembly Overview, Generation II and III
After the installation the vehicle must be measured.
-
Perform vehicle alignment. Refer to => [ Measurement Procedure ] See: Alignment/Service and Repair/Measurement Procedure.
-
Perform basic setting for steering angle sensor.
-
Perform basic setting of steering system.