A3 L4-2.0L Turbo (BPY) (2006)
CAUTION!
Thrust piece (T10263/3) must be positioned so that locking tabs on bonded rubber bushing align with opening on thrust piece (T10263/3).
1
Nut (T10263/5)
2
Washer
3
Press Piece (T10263/3)
4
Subframe
5
Bonded Rubber Bushing
6
Press Piece (T10263/2)
7
Hydraulic Cylinder (VAS 6178 )
8
Washer
9
Nut (T10263/5)
10
Spindle (T10263/4)
-
Pretension special tool with bonded rubber bushing.
-
Pull in bonded rubber bushing until stop by operating pump.
‹› When pressing in, ensure bonded rubber bushing only contacts subframe lightly.
‹› => [ Subframe, Diagonal Brace, Transverse Links, Tie Rod and Level Control System Sensor Assembly Overview ] See: Rear Subframe/Service
and Repair/Removal and Replacement/Subframe, Diagonal Brace, Transverse Links, Tie Rod and Level Control System Sensor Assembly
Overview
‹› => [ Wheel Bearing Housing, Bearing Unit, Trailing Arm with Mounting Bracket, Stone Deflector Assembly Overview ] See: Wheel
Bearing/Service and Repair/Removal and Replacement/Rear Suspension/Wheel Bearing Housing, Bearing Unit, Trailing Arm with Mounting
Bracket, Stone Deflector Assembly Overview
‹› => [ Shock Absorber and Coil Spring Assembly Overview ] See: Suspension Strut / Shock Absorber/Service and Repair/Removal and
Replacement/Rear Suspension/Shock Absorber and Coil Spring Assembly Overview
‹› => [ Stabilizer Bar Assembly Overview ] See: Stabilizer Bar/Service and Repair/Rear Suspension/Stabilizer Bar Assembly Overview
-
Vehicle alignment is required. Refer to => [ Wheel Alignment is Necessary When: ] See: Alignment/Service Precautions.
Checking and aligning front/rear axle must take place on a VW/Audi recommended alignment stand.