A3 L4-2.0L Turbo (BPY) (2006)
Wheel Bearing: Removal and Replacement
AWD
Wheel Bearing Housing Bonded Rubber Bushing
Special tools, testers and auxiliary items required
‹› Press Support (30-506B)
‹› Mounting Universal Joint (41-501)
‹› Sleeve (3160)
‹› Assembly Tool (3301)
‹› Support Arm Bearing Tool (3346)
‹› Carrier Bearing Tool (3350)
‹› Torque Wrench (VAG 1332)
Removing
-
Measure dimension from center of wheel to lower edge of wheel housing. Refer to => [ Rear Axle in Curb Weight Position ] See:
Suspension/Service and Repair/Rear Axle in Curb Weight Position.
-
Remove wheel.
-
Remove coil spring. Refer to => [ Coil Spring ] See: Suspension/Suspension Spring ( Coil / Leaf )/Service and Repair/Rear Suspension/Coil
Spring.
-
Remove brake carrier and brake caliper and tie to body with wire.
‹› Do not allow brake caliper to hang from brake line.
-
Remove screw for brake disc and take out brake disc.
-
Remove cover plate.
-
Remove bolt - arrow - for lower transverse link - 1 -.
Pulling Out Bonded Rubber Bushing
-
Install tools as shown in illustration.