A3 L4-2.0L Turbo (BPY) (2006)
Shifter A/T: Removal and Replacement
Selector Lever Handle
Selector Lever Handle
Removing
-
Place selector lever in position "D".
-
Rotate sleeve - 1 - to right and push downward as far as stop.
-
Carefully pull switch - 2 - just enough out of selector lever handle - 3 - until a cable tie can be inserted between button and selector lever handle.
‹› Do not pull out the button any further, otherwise the selector lever handle will be damaged.
-
Secure button in pulled-out position using cable tie - arrow - as shown in illustration.
-
Pull selector lever handle upward and off.
Installing
Install in reverse sequence; note the following points:
-
Place selector lever in position "D".
‹› To install new selector lever handle - 3 -, button - 2 - must be pulled out as far as stop and secured with a cable tie - arrow - or using assembly
aid included with new handle.
‹› If the button was not secured, it must not be pulled out from the handle using mechanical aids. Apply compressed air gun to bottom of handle and