A3 L4-2.0L Turbo (BPY) (2006)
‹› Removing and installing, refer to => [ Over-Center Spring ] See: Over-Center Spring
6
Bushing
7
Pivot pin
8
Clutch pedal
‹› Removing and installing, refer to => [ Clutch Pedal ] See: Clutch Pedal
9
Mounting clip
‹› For clutch master cylinder actuator rod
10
Oil seal
‹› Replace
‹› Between the clutch master cylinder and the bracket
11
Clutch master cylinder
‹› Removing and installing, refer to => [ Clutch Master Cylinder ] See: Clutch Hydraulic System/Clutch Master Cylinder/Service and Repair/02Q
Transmission
12
Clutch Position Sensor (G476)
‹› Removing and installing, refer to => [ Clutch Position Sensor ] See: Clutch Switch/Service and Repair
‹› Can be tested in "Guided Fault Finding" with the Vehicle Diagnostic, Testing and Information System (VAS 5051 ).
13
Retaining clip
‹› To remove and install the hose/line assembly, pull the clip out to the stop
14
Supply hose
‹› To brake fluid reservoir
‹› Made out of rubber or plastic, depending on the model
‹› Supply hose made of plastic with extra seals, refer to => [ Vehicle with a Plastic Supply Hose ] See: Clutch Hydraulic System/Service and
Repair/Removal and Replacement/Hydraulics Assembly Overview
15
Nut
‹› For the bracket on the bulkhead
‹› 20 Nm
‹› Quantity: 3
‹› Self-locking
‹› Replace
16
Nut
‹› 25 Nm
‹› Self-locking
‹› Replace
17
End stop