A3 L4-2.0L Turbo (BPY) (2006)
Tighten stainless steel clamps for Hytrel CV boots.
-
Apply V.A.G 1682 CV boot clamping pliers as shown in Illustration. Be sure that edges of clamping pliers are seated in corners - arrows B - of
hose clamp.
-
Tighten hose clamp by turning spindle - A - using a torque wrench (do not tilt pliers during this process).
^
Tightening torque: 20 Nm
Note:
^
Be sure thread of spindle in clamping pliers moves freely. Grease with MoS 2 grease, if necessary.
^
If it does not move freely, e.g. due to dirt in thread, the required clamp tension will not be achieved at the specified torque.
Tightening clamp for rubber CV boot