A3 L4-2.0L Turbo (BPY) (2006)
Window Frame: Service and Repair
Front Window Frame and Window Regulator
Window Frame And Window Regulator, Removing And Installing
NOTE: Disconnect battery before disassembling window frame or door.
1
-
Window frame
CAUTION: A sensor for side airbag is located on inside of door - arrow -, observe safety precautions for airbag.
-
Removing:
-
Remove door trim.
-
Disconnect electrical harness connectors.
-
Remove window regulator motor
-
Remove bolts - 4 -;- 6 -;- 9 - and - 10 -.
-
Remove bolts - 7 - from window regulator at bottom.
-
Remove bolts - 8 - at top of window frame and lift window frame with window regulator upward and out of door.
-
Installation:
-
Lower window into window frame half way before installing.
-
Insert window frame and window regulator into door from above.
-
Knock in the upper profile halves of door-side seal into window frame at top.
NOTE: Window frame can be adapted to the door by loosening the longitudinal adjustment screw - a -.
-
Loosely screw in mounting bolts in the sequence - 4 -;- 10 -;- 6 - and - 9 -.
-
Tighten collared shoulder bolts - 4 - and - 10 - hand tight.
-
Lightly press window frame - 1 - inward at top.
-
Tighten collared shoulder bolts - 4 - and - 10 - to 32 Nm.
-
Unscrew adjustment screws for longitudinal adjustment - arrow c - and for inclination - arrow b - to stop using an Allen wrench (width
across flats 9 mm).
-
Tighten bolts - 6 - and - 9 - to 32 Nm.