A3 L4-2.0L Turbo (CBFA) (2008)
/Page-3123001.png)
Trim Panel: Service and Repair
Roof Panel Trim
Roof Panel Trim
Removing
-
Carefully remove roof panel trim - 1 - from roof frame - arrows -.
Installing
Installation is reverse of removal, but note the following:
NOTE: Replace damaged spring clamps.
-
Press roof end trim spring clips - 1 - into mounts on roof frame.
-
Ensure guide pin - 2 - engages in mounting hole.
NOTE: If the guide pin does not engage in the mounting hole, the roof end trim may not be pressed on completely.
-
Fold rear lid rubber seal over rear edge of roof end trim.