A3 L4-2.0L Turbo (CBFA) (2008)
Clutch Disc: Procedures
Determining Clutch Manufacturer
Determining Clutch Manufacturer - 6 Spd. Manual Transmission 02Q Front Wheel Drive
Note:
^
Dual-mass flywheel, pressure plate and clutch plate are allocated to each other and must not be mixed with other manufacturers components.
^
Make sure centering sleeves for engine to transmission are installed in cylinder block, install if necessary.
^
If centering sleeves are not present, shifting difficulties, clutch problems and possibly noise in transmission (loose gear rattling) will occur.
A clutch could be installed from either of the manufacturers, "Sachs" or "LuK".
Clutch makes can be differentiated with transmission installed as follows:
-
Remove center noise insulation -1 through 3-.
Some recesses -arrows- are located between engine -A- and transmission -B- in lower area of engine oil pan.
-
Through these recesses, inspect outer contour of flywheel.