Audi Workshop Service and Repair Manuals

• Combi bolt
• ◆ 30 Nm
• Rear door
• Shim plate
• ◆ Install as required.
• ◆ Note the number and thickness of the bases before installation and install the same bases in the same places.
• Door subframe
• ◆ Removal:
• ‒ Removing door trim.

=> General Body Assembly, Interior; Repair group 70

• ‒ Remove bolts -1- and -5-.
• ‒ Lift out door subframe.
• ‒ Detach Bowden cable for door locking .
• ‒ Disengage bellows at B-pillar and disconnect electrical wiring and pneumatic lines.
• ◆ Installation:

Note:

Door shell -2- must already be adjusted .

• ‒ Install in reverse order.
• ‒ Insert door subframe in door shell and screw on loosely with bolts -1- and -5- with adjusting wedge -4-.
• ‒ Bolts -1- and -5- must be tightened in sequence a; b; c; d.
• ◆ Adjusting:
• ‒ Adjusting =>Page58-23.

• Adjuster wedge

Note:

Adjuster wedge must always be fitted.

• ◆ Angle of door can be adjusted in C-pillar area by shifting adjuster wedge -4- .

• Bolt (2x)
• ◆ Tightening torque 30 Nm.
• Bowden cable
• ◆ Inserting in door lock => Page 58-6.