Audi Workshop Service and Repair Manuals

• Belt tensioner

• ◆ Removing three-point seat belt:
• ‒ Disconnect battery.
• ‒ Remove side trim
• ‒ Remove luggage compartment trim
• ‒ Remove D-pillar trim
  without head airbag => Page 70-118
• ‒ Unplug electrical connector -3- at belt tensioner.

• ‒ Pull insulation -7- back on one side until bolt -2- is reached.
• ‒ Unscrew bolt -2-.

Note:

When unscrewing bolt -4- ensure that spacer bush -5- cannot drop into a cavity.

• ‒ Unscrew bolt-4-.
• ‒ Unscrew bolt -6- (1x)
• ‒ Remove seat belt -1- from mount -10- with locating pin -9-.

• ◆ Installing
• ‒ Install in reverse sequence to removal.

• ‒ Attach insulation with adhesive strips -8-.
• ‒ Fit belt turned through 180°-arrow-.
• ◆ After installing the three-point seat belt, check belt function for child seat => Page 69-46
• ‒ After installing the three-point seat belt, check belt-fastened sensor => Page 69-47

• Bolt (1x)
• ‒ Tightening torque 55 Nm
• Belt tensioner connector
• Bolt (1x)
• ‒ Tightening torque 55 Nm
• Spacer bush

• Bolt (1x)
• ‒ Tightening torque 55 Nm
• Insulation
• Adhesive strips
• Anti-twist element
• Mounting

Notes:

• ◆ After connecting the battery, please ensure that the vehicle accessories (radio, clock, electric window lifters) are checked according to workshop manual and/or operating instructions.
• ◆ If the fault warning light (K 75) for airbag signals a fault after assembly the fault memory must be erased and again be interrogated by using fault reader V.A.G 1551.

=> Body Self-diagnosis; Repair group 01