Audi Workshop Service and Repair Manuals

• Bowden cable

• ◆ Removing
• ‒ Remove seat
• ‒ Remove bolt -3- (1x).
• ‒ Detach lever -4- and adjuster grip -5-.
• ‒ Open cable ties -2-.
• ‒ Push lugs -9- (4x) outwards and pull clamp -8- in direction of arrow.
• ‒ Remove Bowden cable -1- from bracket -10-.
• ‒ Push one of the retaining hooks -6- inwards from inside.

• ‒ Detach Bowden cable -1- at cut-out -7-.

• ◆ Installing

Note:

Observe setting of Bowden cable -1- to ensure that the seat is securely locked in position.

• ‒ Using clamp -8-, adjust Bowden cable -1- such that there is approx. 1 mm play at adjuster grip -5-.

• Cable tie
• Bolt
• ‒ Tightening torque 5 Nm
• Lever
• ◆ Lever -4- and adjuster grip -5- are one replacement part.

• Adjuster grip handle
• Locking tab
• Cut-out
• Clamp
• Retainer tabs
• Bracket
• Slider block
• ◆ Cut through rivet to remove => Fig.2

Fig.2    Cutting through rivet to remove slider block

• ‒ Operate release lever for longitudinal seat adjustment and push slider block to the rear.
• ‒ → Using a metal saw -3- cut through sleeve -2- and rivet -1-.
• ‒ Remove all metal particles from seat pan.
• ‒ The rivet -1- is replaced by the service department with a bolt, a nut and a new sleeve -2-.
• ‒ Tightening torque 15 Nm