Audi Workshop Service and Repair Manuals

Notes:

• ◆ The operating and display units with the part number 9L0 820 043 and the indices "H", "J", "K" and "L" and as of "O" are equipped with one display.
• ◆ In vehicles with map-controlled cooling the coding of the operating and display unit -E87 is different than vehicles without map-controlled cooling.
• ◆ The main differences between the codes for "Rest of world" and "USA" or "Japan" are as follows:
  USA = Temperature display in °F has priority over °C.
  Japan = The function "Manually actuated
  air circulation" is not erased
  when ignition is switched off.

• ‒ Connect fault reader V.A.G 1551,
  Enter address word 08 "Electronic climate/heating control" and advance the program until "Select function XX" appears on display onwards.
• ‒ Switch on printer by pressing PRINT key (lamp in key lights up).

• ‒ Press keys -0- and -7- (07 selects the "Encoding control unit" function.)

• ‒ Press Q to confirm entry.

Note:

Next position can be selected by pressing the ⇒ key.

Different codes:

• ◆ Codes for operating and display unit -E87 with the following indices:
  - Indices "H", "J, "K" or "L"
  - and from index "O" onwards

Examples of code

• ‒ Encode operating and display unit -E87 according to the vehicle type, engine and country.
• ‒ Press Q to confirm entry.
• ‒ Perform basic setting .

Notes:

• ◆ If a wrong coding was entered into the operating and display unit -E87 it will be suppressed. The fault "coding XXXXX not accepted" is displayed and the old coding remains intact.
• ◆ If an operating and display unit -E87 is newly installed (out of spare part programme) it is coded with "00001".
• ◆ Assignment of operating and display unit
  -E87.

=> Parts List