–
| Detach pipe/hose assembly from bracket on clutch slave cylinder. |
–
| Then remove bolts -arrows- and detach slave cylinder from release shaft on gearbox. |
–
| Using hose clamp -3094-, clamp off pipe/hose assembly going to slave cylinder. |
–
| Pull out clip → Item and then pull pipe/hose assembly out of slave cylinder. Seal end of pipe. |
Installation is carried out in reverse sequence; note the following: |
–
| Press clip → Item into slave cylinder as far as stop. |
–
| Push hose/pipe assembly into clutch slave cylinder until it engages audibly. |
–
| Lubricate end of plunger with MoS2 grease. |
–
| Fit slave cylinder to release shaft and secure onto gearbox. |
–
| After installing slave cylinder, bleed clutch system → Chapter. |
–
| Install noise insulation below engine/gearbox. |
|
|
|