Audi Workshop Service and Repair Manuals > A3 Mk1 > Power transmission | 5/6-speed manual gearbox 02M/02Y, four-wheel drive | Clutch, control | Servicing clutch mechanism | Removing and installing clutch slave cylinder (release bearing with hydraulic actuator)

Removing and installing clutch slave cylinder (release bearing with hydraulic actuator)

Note

Slave cylinder and release bearing are one unit and can only be renewed together.

Removing

–	Remove gearbox → Chapter.

–	Remove bolts -arrows-.

–	Pull out release bearing -A- together with clutch slave cylinder.

Installing

Installation is carried out in reverse sequence; note the following:

–	Install gearbox → Chapter „Installing gearbox“.

–	Bleed clutch system → Chapter.

Tightening torque

Component	Nm
Clutch slave cylinder to gearbox	12

Audi Workshop Service and Repair Manuals