A3 Mk1
| Clutch release mechanism - exploded view of components |
| 1 - | Gearbox |
| 2 - | Oil seal |
| q | For input shaft |
| q | Renewing → Chapter |
| 3 - | Release bearing with hydraulic actuator |
| q | One unit; can only re renewed together |
| q | Do not wash out bearing; wipe clean only |
| q | Renew complete release bearing with hydraulic actuator if noises occur. |
| q | Removing and installing → Chapter |
| 4 - | Bolt, 12 Nm |
| q | 3 x |
| q | For correct version check engine code and refer to → Parts catalogue |
| 5 - | Seal/O-ring |
| q | Renew; for correct version refer to → Parts catalogue |
| q | Whether a seal or an O-ring is used depends on the type of connection → Fig.. |
| q | Lubricate with brake fluid before installing |
| q | Push onto pipe connection |