Audi Workshop Service and Repair Manuals

Note:

Lubricate all mountings and sliding surfaces with Polyurea grease Part No. G 052 142 A2.

• Lock washer
• ◆ Removing and installing
  =>Fig.1
• Bush
• Spring
• Bush
• Torx socket head bolt, 6 Nm
• Cover plate
• Damper
• Bearing shell
• ◆ Insert in damper (Item 7)

• Gear stick guide
• Damping washer
• Gasket
• ◆ Between gear stick housing and floor
• ◆ Self-adhesive
• ◆ Bond to gear stick housing
• Gear stick
• Damper
• ◆ Press onto gear stick housing
• Gear stick housing
• Bush
• ◆ Only fits in one position
• Bolt, 25 Nm
• Fulcrum pin
• Guide bush
• ◆ Press onto gear stick housing

• Spring
• ◆ Installing=>Fig. 2
• Gate selector bracket
• Torx socket head bolt, 6 Nm
• Base plate
• ◆ Bend open tabs to remove.
• ◆ Renew
• Lock washer
• Gate selector cable
• ◆ On gate selector bracket
• ◆ Installation position
• Gear selector cable
• ◆ Press onto gear stick guide
• ◆ Installation position => Page 34-1

• Hexagon nut, 25 Nm
• Bush
• ◆ Only fits in one position
• Lock washer

→ Fig.1    Removing and installing circlip

• ‒ To remove and install the circlip pull gear stick in arrow direction -A- and at the same time push down spacer bush onto stop with a screwdriver in arrow direction -B-.

Note:

Do not tilt spacer bush when pushing down. Carefully release pressure at groove in gear stick for circlip.

→ Fig.2     Installing spring

• ‒ Insert spring so that the spring extension -A- lies above pin (arrow).
• ‒ Then pull spring extension -B- down so that it reaches below pin (arrow).