audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing conductor strip with 10-pin connector > < Operating rod for manual selector valve - renewing steel spring and bolt for selector shaft

A3 Mk1

Adjusting operating rod for manual selector valve
Adjusting operating rod for manual selector valve
Procedure
  Note
The bolt with steel spring must always be renewed after removal → Chapter.
–  Shift selector shaft into position “P”.
   
–  Push operating rod with manual selector valve into valve body as far as the stop in direction of -arrows- and tighten bolt securing lever.
l  Tightening torque: 4 Nm
  Note
t  Before adjustment can be performed, the manual selector valve must be inserted in the valve body as far as it will go. Counter-hold in direction of -arrow- when tightening bolt.
t  Do not apply pressure to small limiting lever for steel spring, otherwise adjustment will be incorrect.
t  Check: in selector lever position “1”, manual selector valve must be flush with outside of valve body.
  V38-0709

Removing and installing conductor strip with 10-pin connector > < Operating rod for manual selector valve - renewing steel spring and bolt for selector shaft