|
Removing and installing cylinder head -Vehicles with four-wheel drive-
Removing and installing cylinder head -Vehicles with four-wheel drive-
Notes:
-
◆ Cylinder heads with tears can be used between the valve seats without reducing the service life if the tears are slight and at the most 0.5 mm wide.
-
◆ When fitting a new cylinder head or cylinder head gasket, drain off all the old coolant and re-fill with new coolant.
-
◆ When engine oil is contaminated perform oil change:
=> Maintenance Manual
-
◆ The cylinder heads on a diesel engine must not be reworked.
-
◆ When installing an exchange cylinder head with fitted camshaft, the contact surfaces between tappets and cams must be oiled after installing the head.
-
◆ The plastic protectors fitted to protect the open valves must only be removed immediately before fitting the cylinder head.
-
◆ Removing and installing tandem pump:
=> Fuel Supply - Diesel Engines; Repair group 20
|
