A3 Mk1
Note
|
1 - | Poly V-belt |
q | Routing of belt on vehicles without air conditioner → Fig. |
q | Routing of belt on vehicles with air conditioner → Fig. |
q | Double-sided poly V-belt on vehicles with air conditioner |
q | Before removing, mark direction of rotation with chalk or felt-tipped pen. If the belt runs in the opposite direction when it is refitted, this can cause breakage. |
q | Check for wear |
q | Do not kink |
q | Removing and installing → Chapter |
2 - | 23 Nm |
3 - | Poly V-belt tensioner |
q | Turn with open-end spanner to slacken poly V-belt → Anchor |
4 - | Vibration damper |
q | With pulley for poly V-belt |
q | Removing and installing → Chapter |
5 - | 45 Nm |
6 - | 23 Nm |
7 - | Alternator |
q | Removing and installing → Rep. Gr.27 |
q | To facilitate attachment of alternator, knock back threaded bushes for alternator securing bolts slightly |
8 - | Air conditioner compressor |
q | Removing and installing → Rep. Gr.87 |
q | After detaching, secure compressor to lock carrier using wire or similar. Do not leave it suspended from refrigerant pipes. |
q | Do not unscrew or disconnect refrigerant hoses or pipes. |
q | To facilitate attachment of air conditioner, knock back threaded bushes for securing bolts slightly |
9 - | Spacer bush |
10 - | Bracket for ancillaries |
q | Removing and installing → Chapter |
11 - | 45 Nm |
12 - | 23 Nm |
13 - | 23 Nm |
14 - | Power steering pump |
q | Removing and installing → Rep. Gr.48 |
q | To facilitate positioning of power steering pump, drive back threaded bush for securing bolt slightly at bracket |
15 - | Pulley for power steering pump |
16 - | 23 Nm |
17 - | Special bolt |
q | For correct version refer to → Parts catalogue |
q | If property class is 8.8, renew bolt and tighten to 10 Nm + 90° further |
q | If property class is 10.9, tighten to 40 Nm |
|
Note
|