A3 Mk1
Sealing flanges and pressure plate/drive plate - exploded view of components |
Note
Servicing clutch → Rep. Gr.30 |
1 - | 15 Nm |
2 - | Oil seal |
q | Renewing → Chapter |
q | Do not lubricate with oil |
3 - | Sealing flange (front) |
q | Should be positioned on dowel pins |
q | Removing and installing → Chapter |
4 - | Stud, 10 Nm |
q | Install using locking fluid; for locking fluid refer to → Parts catalogue |
5 - | Cylinder block |
6 - | Seal |
q | Renew |
7 - | Screw plug, 100 Nm |
8 - | Securing bolt for pressure plate/drive plate |
q | Renew |
q | Tightening torque: vehicles with manual gearbox → Anchor; vehicles with automatic gearbox → Anchor |
9 - | Intermediate piece |
q | Installation position → Fig. |
10 - | Pressure plate/drive plate |
q | Removing and installing pressure plate → Chapter |
q | Removing and installing drive plate → Chapter |
q | Can only be installed in one position (holes are off-set) |
11 - | Intermediate plate |
q | Must be positioned on dowel sleeves |
q | Do not damage/bend when assembling |
q | Is fitted on sealing flange → Fig. |
12 - | Rear sealing flange |
q | With oil seal |
q | Removing and installing → Chapter |
q | Do not lubricate with oil |
|
|