Audi Workshop Service and Repair Manuals

Special tools, workshop equipment, test and measuring appliances and auxiliary items required

• ◆ 3240 Oil seal extractor
• ◆ 3415 Counter-hold tool
• ◆ T10022 Sleeve
• ◆ T10022/1 Press piece
• ◆ T10022/2 Spindle

Removing

• ‒ First remove toothed belt
  .
• ‒ → Remove crankshaft toothed belt sprocket. To do this counter-hold sprocket with 3415.
• ‒ To guide oil seal extractor screw crankshaft sprocket securing bolt into crankshaft onto stop.
• ‒ Unscrew inner part of oil seal extractor 3240 two turns (approx. 3 mm) out of the outer part and lock with knurled screw.

• ‒ → Lubricate threaded head of oil seal extractor, place it in position and exerting firm pressure screw it as far as possible into oil seal.
• ‒ Loosen knurled screw and turn inner part against crankshaft until the oil seal is pulled out.

Installing

• ‒ Lightly oil sealing lip of oil seal.
• ‒ → Fit sleeve T10022 onto crankshaft journal and turn spindle T10022/2 in onto stop.
• ‒ Slide oil seal over guide sleeve.

• ‒ → Press in oil seal onto stop with press piece T10022/1.

• ‒ → Install crankshaft sprocket and counter-hold with 3415.
  Tightening torque: 90 Nm + 1/4 turn (90 °) further

Installing toothed belt and adjusting timing.