Audi Workshop Service and Repair Manuals

Special tools and workshop equipment required

• ◆ V.A.G 1526 A
• ◆ V.A.G 1594 A
• ◆ V.A.G 1598/31

Test requirements:

• ● Coolant temperature at least 80 °C=>Display group 004, display zone 3
• ● Fuse for lambda probe heating OK

=> "Current Flow Diagrams, Electrical Fault-finding and Fitting Locations" binder

Test sequence

• ‒ → Unscrew protective cover -arrows- on underside of vehicle.

• ‒ → Unplug 4-pin connector -1- (brown) for lambda probe downstream of catalytic converter -G130.

• ‒ → Connect up multimeter for resistance measurement between contacts 1 and 2.
• ‒ Specification at ambient temperature: 6.4 ... 47.5 ω

If reading does not match specification:

• ‒ Replace lambda probe downstream of catalytic converter -G130.

If reading matches specification:

• ‒ Check power supply for lambda probe heating.

Checking power supply for lambda probe heating

• ‒ → Connect up multimeter for voltage measurement between contacts 1 (positive) and 2 (earth).
• ‒ Start engine.
• ‒ Specification: approx. battery voltage

Note:

Activation and deactivation of lambda probe heating by engine control unit can be observed if necessary in function "Read measured value block", display group number 041, display zone 4.

If there is no voltage:

• ‒ → Connect up multimeter for voltage measurement as follows.

• ‒ Briefly operate starter.
• ‒ Specification: approx. battery voltage

If there is still no voltage:

• ‒ Check for open circuit in wiring from contact 1 of connector via fuse to fuel pump relay.

=> "Current Flow Diagrams, Electrical Fault-finding and Fitting Locations" binder

If power supply is OK:

• ‒ → Connect up multimeter for voltage measurement as follows.

• ‒ Start engine.
• ‒ Specification: approx. battery voltage (may fluctuate)
• ‒ Switch off ignition.

If there is no voltage:

• ‒ Connect test box V.A.G 1598/31 to engine control unit wiring harness. Actual engine control unit is not to be connected.

• ‒ → Check for open circuit in the following wiring.

• ‒ Eliminate open circuit in wiring if necessary.

If wiring is OK, but there is no earth supply for lambda probe heating:

• ‒ Replace engine control unit .