A3 Mk1
Checking ignition system
Checking engine speed sender -G28
|
Special tools and workshop equipment required
Fitting location => Fitting locations overview, Page 24-5 Note: The engine speed sender is a combined speed sender and reference mark sender. The engine cannot be started without a signal from the -G28 engine speed sender. If the signal from the -G28 engine speed sender fails while the engine is running, the engine will cut out immediately. Test sequence
|
Note: The resistance value of the engine speed sender is associated with a temperature of 20 °C. The resistance increases if the temperature increases. If specified value is not attained:
If specified value is attained: |
If specified value is not attained:
If specified value is attained:
|
If no wiring fault is detected:
|