audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Checking misfiring detection for the individual cylinders > < Checking Hall sender G40

A3 Mk1

Checking misfiring detection
Checking misfiring detection
–  Connect up the vehicle diagnostic and service information system -VAS 5052- and select the engine electronics control unit. Engine must be idling.
–  Select the function “Read measured value block”.
–  Select “Display group number 014”.
–  Check misfiring detection.
   
 Display zones
 1234
Display group 014: Misfiring detection
Displayxxx rpmxxx %xxx---
DisplayEngine speedLoadTotal misfiringMisfiring detection
Operating range   Activated
disabled
Specificationxxxx rpm12.75...30 %0Activated
Note  If value is above specified range: check misfiring of the individual cylinders → ChapterMisfiring detection is disabled if misfiring is to be expected on account of the operating status (e.g. warm-up, overrun shut-off)

   

Checking misfiring detection for the individual cylinders > < Checking Hall sender G40