Audi Workshop Service and Repair Manuals

• ‒ Read measurement block display group 07, engine cool and not running

• ‒ Observe readout in display zone 1.

• If the wiring to the sensor has an open circuit, a substitute value of -5.4 °C will be displayed.

If the display is implausible or if a substitute value of -5.4 °C is displayed:

• ‒ Connect test box V.A.G 1598/31 to wiring harness for engine control unit; do not connect the engine control unit => Page 23-32.
• ‒ Remove connector from injection pump =>Fitting locations overview, page 23-4.

The following wiring connections are to be checked for open circuits and/or short to positive or negative.

• ‒ Rectify any open/short circuit as necessary.

=> Current Flow Diagrams, Electrical Fault-finding and Fitting Locations binder