Servicing Diesel direct injection system
Safety precautions
To prevent injuries to persons and/or damage to the injection and glow plug system, the following must be noted:
-
◆ The ignition must be switched off before connecting or disconnecting injection or glow plug system wiring or tester cables.
-
◆ If the engine is to be turned at starter speed, without starting, e.g. when checking compressions, disconnect unit injector connector on cylinder head.
-
◆ Always use measuring appliance set V.A.G 1594 A to connect test instruments (such as voltage tester V.A.G 1527 B or hand-held multimeter V.A.G 1526 A etc.).
Observe following if test and measuring instruments are required during a test drive:
Warning
-
◆ Test equipment must always be secured on the rear seat and operated from the rear seat by a second person.
-
◆ If test equipment is operated from the front passenger seat, the occupant could be injured by the passenger's airbag in an accident.
|