Removing and installing gas-discharge lamp starter unit -N195
Electrical system
Servicing headlights - as of Model Year 2001
Removing and installing gas-discharge lamp starter unit -N195
Attention: High voltage Always disconnect battery earth strap before working on gas-discharge headlight components marked with yellow high-voltage symbols.
Removing
‒ Remove headlight .
‒ → Release headlight range control motor: At right headlight by turning anti-clockwise; at left headlight by turning clockwise -arrow-
‒ By tilting control motor, push ball end of positioning stem out of socket.
‒ Detach cover from headlight housing.
‒ → Unplug connector -1- at gas-discharge lamp by turning anti-clockwise -arrow-.
‒ → Unplug connector -3- at main beam bulb.
‒ Disengage spring clip -2- and take bulb -1- out of housing.
‒ → Turn adjuster -3- until headlight reflector is swivelled completely forwards.
‒ Unclip cable guide -2- from inside.
‒ Unplug connector -1-.
Installing
Install in reverse order, paying attention to the following:
‒ Install headlight range control motor => Page 94-57.