audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Fitting list > < Adapting electronic log book

A3 Mk1

Adapting CAN bus users
Adapting CAN bus users
Control units fitted must be set in adaption channel 07. Navigation system control unit monitors CAN bus communication.
CAN bus communication status can also be indicated on navigation system display by simultaneously pressing AS and V keys.
Indicated on display of navigation system II-D:
   
FM1AerialTP
Card reader:Not encoded
TV tuner:Ok
Gateway:No link
Telematics system:Ok
Multi-function steering wheel:Ok
VCS:Ok
Dash panel insert:Ok
Communication statusBack to RETURN

t  Not encoded: Unit not fitted or fitted but not encoded
t  No link: Unit encoded but not fitted
t  Activate term. 15: Unit encoded but no terminal 15 signal
   
Indicated on display:
–  Press keys 0 and 7 (07 is used to select “Channel 7”).
  Note!
An incorrect entry can be corrected after pressing C key.
–  Confirm entry by pressing Q key.
  
Adaption
Enter channel number XX
Indicated on display:
Channel selected and relevant configuration are displayed on top line (fitting list → Chapter).
–  Press → key.
  
Channel 7     Adaption      6        ->
                          <-1 3->
Indicated on display:
–  Enter new adaption value (e.g. 00006) (fitting list → Chapter).
–  Confirm entry by pressing Q key.
  
Channel 7     Adaption      0        ->
Enter adaption value XXXXX
Indicated on display:
–  Press → key.
  
Channel 7     Adaption      6        ->
                          <-1 3->
Indicated on display:
–  Confirm entry by pressing Q key.
  
Channel 7     Adaption      6         Q
Store altered value?
Indicated on display:
–  Press → key.
  
Channel 7     Adaption      6        ->
Altered value stored
Indicated on display:
–  Press keys 0 and 6 (06 is used to select “End of output” function).
–  Confirm entry by pressing Q key.
  
Rapid data transfer                HELP
Select function XX

Fitting list > < Adapting electronic log book