A3 Mk2
Exploded view - LuK version clutch |
„SAC“ stands for „Self-Adjusting Clutch“. |
1 - | Dual-mass flywheel |
q | Removing and installing → Engine, mechanics; Rep. gr.13 |
q | Ensure that dowel pins fit tightly |
q | Contact surface for clutch lining must be free of scoring, oil and grease |
q | Observe instructions for removal → Fig. |
2 - | Clutch plate |
q | Removing and installing → Chapter |
q | Always renew SAC pressure plate as well |
q | The marking „Getriebeseite“ (gearbox side), if provided, faces towards pressure plate/gearbox |
q | For correct version, refer to → Electronic parts catalogue |
3 - | SAC pressure plate |
q | Removing and installing → Chapter |
q | Only fits on flywheel in one position |
q | Checking ends of diaphragm spring → Fig. |
q | Check rivets and spring connection → Fig. |
q | Always renew clutch plate as well |
q | For correct version, refer to → Electronic parts catalogue |
4 - | Bolt |
q | M6 - 13 Nm |
q | M7 - 20 Nm |
q | 6x |
q | Loosen and tighten gradually in small steps → Chapter |
Note
|