audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Exploded view - servicing selector unit > < Exploded view - servicing gearbox housing and clutch housing

A3 Mk2

Removing and installing gearbox neutral position senderG701
Removing and installing gearbox neutral position sender -G701-
l  Only in vehicles with start/stop system
l  Gearbox installed
   
Removing
–  Remove noise insulation -1- → General body repairs, exterior; Rep. gr.50.
  A10-10917
–  Unplug electrical connector -2- from gearbox neutral position sender -G701-.
  Note
Items marked -1- and -3- can be disregarded.
  A10-11182
–  Remove bolt -arrow- and pull out gearbox neutral position sender -G701--A-.
  Note
Gearbox neutral position sender -G701- is shown with gearbox removed.
Installing
–  Install gearbox neutral position sender -G701- and tighten securing bolt -arrow- to specified torque → Item.
  N34-11245
–  Plug in connector -arrow- at gearbox neutral position sender -G701-.
–  Install noise insulation (centre) -1- → General body repairs, exterior; Rep. gr.50.
  N34-11243

Exploded view - servicing selector unit > < Exploded view - servicing gearbox housing and clutch housing