A3 Mk2
| Exploded view - clutch release mechanism |
| 1 - | Release bearing |
| q | Remove and install together with release lever → Item and guide sleeve → Item → Chapter |
| q | Do not wash out bearing; wipe clean only |
| q | Renew bearing if noisy |
| q | Lubricate surfaces which contact release lever with MoS2 grease |
| 2 - | Bolt |
| q | Renew |
| q | 5 Nm + 90° |
| 3 - | Clutch release lever |
| q | Remove and install together with release bearing → Item and guide sleeve → Item → Chapter |
| q | Remove existing grease |
| q | Lubricate surface which contacts ball head stud with MoS2 grease |
| 4 - | Retaining spring |
| q | Secure to clutch release lever |
| 5 - | Guide sleeve |
| q | Remove and install together with release bearing → Item and release lever → Item → Chapter |
| 6 - | Input shaft oil seal |
| q | Renewing → Chapter |
| 7 - | Ball head stud |
| q | Remove existing grease from contact surface of release lever |
| q | Lubricate with grease -G 000 100- |
| q | 20 Nm |
| 8 - | Gearbox |
| 9 - | Bolt |
| q | Tightening torque → Item |
| 10 - | Bracket |
| q | For pipe/hose assembly |
| 11 - | Clutch slave cylinder |
| q | Removing and installing → Chapter |
