A3 Mk2
Exploded view - pedal cluster, clutch master cylinder |
Note
Lubricate all bearings and moving surfaces with grease -G 000 450 02-. |
1 - | Pipe/hose assembly or plastic pipe |
q | With frequency modulator on some versions |
q | For correct version, refer to → Electronic parts catalogue |
q | Disconnecting from clutch master cylinder and clutch slave cylinder → Fig. |
q | Removing and installing → Chapter |
2 - | Seal or O-ring |
q | Matched to type of connection → Fig. |
q | For correct version, refer to → Electronic parts catalogue |
q | Renew damaged seals or O-rings |
q | Push onto pipe connection |
q | Lubricate with brake fluid before installing |
3 - | Clip |
4 - | Supply hose |
q | To brake fluid reservoir |
q | Made of rubber or plastic, depending on version |
q | Plastic supply hose with additional seals → Fig. |
5 - | Nut |
q | 3x |
q | Self-locking |
q | Renew |
q | 20 Nm |
6 - | Gasket |
q | Renew |
7 - | Mounting bracket |
q | For clutch pedal |
q | Removing and installing → Chapter |
8 - | Bolt |
9 - | Bearing bush |
10 - | Pivot pin |
11 - | Clutch pedal |
q | Removing and installing → Chapter |
12 - | Bearing bush |
13 - | Nut |
q | Self-locking |
q | Renew |
q | 25 Nm |
14 - | Retaining clip |
q | For operating rod on clutch master cylinder |
15 - | Over-centre spring |
q | Removing and installing → Chapter |
16 - | Seal |
q | Renew |
17 - | Clutch master cylinder |
q | Removing and installing → Chapter |
18 - | Clutch position sender -G476- |
q | Removing and installing → Chapter |
q | Checking in “Guided Fault Finding” → Vehicle diagnosis, testing and information system VAS 5051 |
|