audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Clutch identification > < Exploded view - clutch release mechanism, clutch slave cylinder
Removing and installing clutch slave cylinder with release bearing
Removing and installing clutch slave cylinder with release bearing
  Note
Clutch slave cylinder and release bearing are one unit and can only be renewed together.
   
Removing
–  Remove gearbox → Chapter.
–  Release retaining clip -2- with a screwdriver and pull bleeder connection -4- off slave cylinder -1-.
  A30-0137
–  Remove bolts -arrows-.
–  Take off slave cylinder together with release bearing -A-.
Installing
Installation is carried out in reverse sequence; note the following:
  Caution
Tighten securing bolts for clutch slave cylinder in small steps. Otherwise mounting lugs -arrows- can be damaged.
–  Secure clutch slave cylinder and release bearing -arrows-. Tightening torque → Item
  A30-0012
–  Check O-ring -3- for damage and renew if necessary.
–  Press bleeder connection -4- onto connection on clutch slave cylinder -1- so that retaining clip -2- snaps into place.
–  Pull on bleeder connection to check it is secure.
–  Install gearbox → Chapter.
–  Bleed clutch system → Chapter.
  A30-0137

Clutch identification > < Exploded view - clutch release mechanism, clutch slave cylinder