A3 Mk2
Exploded view - Sachs version clutch |
Note
The dual-mass flywheel, pressure plate and clutch plate are matched together; components from another manufacturer must not be installed on the same vehicle. |
1 - | Dual-mass flywheel |
q | Removing and installing → Engine, mechanics; Rep. gr.13 |
q | Ensure that dowel pins fit tightly |
q | Contact surface for clutch lining must be free of grooves, oil and grease |
q | Observe instructions for removal → Fig. |
2 - | Clutch plate |
q | Removing and installing → Chapter |
q | Always renew pressure plate as well |
q | Installation position → Fig. |
q | For correct version, refer to → Electronic parts catalogue |
3 - | Pressure plate |
q | With adjustment mechanism |
q | Identification → Fig. |
q | Removing and installing → Chapter |
q | Checking ends of diaphragm spring → Fig. |
q | Checking spring connections and rivets → Fig. |
q | Always renew clutch plate as well |
q | For correct version, refer to → Electronic parts catalogue |
4 - | Bolt |
q | M6 - 13 Nm |
q | M7 - 20 Nm |
q | 6x |
q | Loosen and tighten bolts consecutively in steps of 90° |
|