A3 Mk2
Exploded view - removing and installing gearbox housing and selector mechanism |
1 - | Countersunk bolt |
q | 25 Nm |
2 - | Flange shaft with spring |
q | Removing and installing → Chapter |
q | Assembling → Chapter |
3 - | Torx socket head bolt |
q | 25 Nm |
q | For reverse shaft support |
q | Self-locking |
q | Always renew |
4 - | Torx socket head bolt |
q | 30 Nm |
q | For reverse shaft support |
q | Self-locking |
q | Always renew |
5 - | O-ring |
q | Always renew |
6 - | Pivot pin |
7 - | Bolt |
q | 25 Nm |
8 - | Bolt |
q | 25 Nm |
9 - | Sealing cap |
10 - | Multi-point socket head bolt |
q | 25 Nm |
q | For reverse shaft support |
q | Always renew |
11 - | Bolt |
q | 5 Nm |
12 - | Gearbox neutral position sender -G701- |
q | For vehicles with start/stop system |
13 - | Gearbox housing |
q | Pulling off together with 5th/6th gear → Chapter |
q | Servicing → Chapter |
14 - | Clutch housing |
q | Servicing → Chapter |
15 - | Bolt |
q | 25 Nm + 90° |
q | Always renew |
16 - | Selector shaft with selector mechanism cover |
q | (Selector unit) |
q | Servicing → Chapter |
17 - | Multi-point socket head bolt |
q | 25 Nm |