A3 Mk2
| Exploded view - gearbox housing cover |
| 1 - | Roller bearing |
| q | For input shaft |
| q | Do not interchange with roller bearing for output shaft |
| q | Pulling out → Fig. |
| q | Larger diameter on gearboxes manufactured from 21 08 6 onwards → Fig. |
| q | Pressing in on gearboxes manufactured up to 20 08 6: → Fig. |
| q | Pressing in on gearboxes manufactured from 21 08 6 onwards: → Fig. |
| q | Securing → Fig. |
| 2 - | Roller bearing |
| q | For output shaft |
| q | Do not interchange with roller bearing for input shaft |
| q | Larger diameter on gearboxes manufactured from 21 08 6 onwards → Fig. |
| q | Pulling out → Fig. |
| q | Pressing in on gearboxes manufactured up to 20 08 6: → Fig. |
| q | Pressing in on gearboxes manufactured from 21 08 6 onwards: → Fig. |
| q | Securing → Fig. |
| 3 - | Gearbox housing cover |
| q | Modified according to roller bearings on gearboxes manufactured from 21 08 6 onwards → Fig. |
| 4 - | Magnet |
| q | From 11.2010 onwards |
| q | Can only be fitted in a cover with a recess -arrow- |
| 5 - | Clip |
| q | Holds magnet in position |
