A3 Mk2
|
|
Note| After removal, always renew needle bearings in clutch housing and in reverse shaft support. |
| 1 - | Clutch housing |
| 2 - | Needle bearing |
| q | Pulling out → Fig. |
| q | Pressing in → Fig. |
| 3 - | Reverse shaft |
| q | With reverse gear wheel |
| q | Removing and installing → Chapter |
| 4 - | Reverse gear locking collar |
| q | Installation position: dog teeth face towards reverse selector gear |
| 5 - | Thrust washer |
| 6 - | Needle bearing |
| q | For reverse selector gear |
| q | Lubricate with gear oil before installing |
| 7 - | Reverse selector gear |
| q | Installation position: dog teeth face towards locking collar for reverse gear |
| 8 - | Thrust washer |
| 9 - | Needle bearing |
| q | Pressing out → Fig. |
| q | Pressing in → Fig. |
| 10 - | Reverse shaft support |
| q | Removing and installing → Chapter |
