audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Renewing gear oil > < Removing and installing gearbox mounting and gearbox support

A3 Mk2

Removing and installing pendulum support
Removing and installing pendulum support
   
Removing
–  Vehicles with large noise insulation: remove noise insulation -1- → Rep. gr.50.
  A10-10917
–  Unscrew bolts -1 ... 3- and remove pendulum support.
Installing
Installation is carried out in reverse sequence; note the following:
l  Tightening torques → Chapter „Exploded view - assembly mountings“
  Note
Renew bolts which are tightened by turning through a specified angle.
–  First secure pendulum support to gearbox (bolts -2- and -3-), then on subframe -1-.
–  Install noise insulation → Rep. gr.50.
  A10-1578

Renewing gear oil > < Removing and installing gearbox mounting and gearbox support